Thermador Professional PRO HARMONY PRG30 Manuel D'installation page 22

High Shelf
Low Back
Figure 16: High Shelf & Low Back Front View
When installing against a combustible surface, a High
Shelf or Low Backguard is required. A THERMADOR
High Shelf or Low Backguard must be purchased
separately. See clearances on page 6 for more
information.
When using the Flush Island Trim, THERMADOR
recommends a minimum 12" (305 mm) rear clearance to a
combustible surface (see Figure 1, Cabinet Clearances).
Clearances from non-combustible materials are not part of
the ANSI Z21.1 scope and are not certified by
CSA. Clearances of less than 12" (305 mm) must be
approved by the local codes and/or by the local authority
having jurisdiction.
High Shelf Assembly
1. Remove protective plastic.
2. Slide the shelf onto the backguard channel.
3. Install the included stainless screws along the topside
of shelf and into the back of the shelf.
4. Begin with Backguard Installation.
Figure 17: High Shelf Assembly Rear View
English 20
Flush Island Trim
(Included with range)
®
Mounts inside back panel flange
Backguard Installation
1. Remove protective plastic.
2. Depending on model, remove the (3) or (4) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim, the (4) drill point screws securing the trim
to the side panels, and the (2) or (4) drill point screws
securing the piece to the back panel. Lift up to fully
remove.
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws in the new backguard's front and
back panels.
Re-install (4) drill point screws to secure the backguard's
back panel to the side panels on the back of the range.
High Shelf
Low Back
Figure 18: Backguard Installation