Husqvarna 335LS Manuel D'utilisation page 27

Contents
KEY TO SYMBOLS
Symbols .................................................................... 26
CONTENTS
Contents .................................................................... 27
Note the following before starting: ............................. 27
INTRODUCTION
Dear customer! .......................................................... 28
WHAT IS WHAT?
What is what on the clearing saw? ............................ 29
GENERAL SAFETY PRECAUTIONS
Important ................................................................... 30
Personal protective equipment .................................. 30
Machine's safety equipment ...................................... 31
Cutting equipment ..................................................... 34
ASSEMBLY
Fitting the loop handle ............................................... 35
Assembling the cutting equipment ............................ 35
FUEL HANDLING
Fuel safety ................................................................. 36
Fuel ........................................................................... 36
Fueling ...................................................................... 37
STARTING AND STOPPING
Check before starting ................................................ 38
Starting and stopping ................................................ 38
WORKING TECHNIQUES
General working instructions ..................................... 40
MAINTENANCE
Carburetor ................................................................. 42
Muffler ....................................................................... 43
Cooling system .......................................................... 44
Bevel gear ................................................................. 44
Air filter ...................................................................... 44
Spark plug ................................................................. 45
Maintenance schedule .............................................. 46
TECHNICAL DATA
Technical data ........................................................... 47
FEDERAL AND CALIFORNIA EMISSIONS
CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS ... 48
The engine exhaust from this product
contains chemical known to the State
of California to cause cancer, birth
defects or other reproductive harm.
CONTENTS
Note the following before starting:
Please read the operator's manual carefully.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.
!
!
!
This label certifies that the product has been certified in
accordance with American exhaust requirements EPA 2.
This engine label certifies that the product is certified in
accordance with American exhaust emissions requirements
EPA Ph II and Californian exhaust and evaporative
emissions requirements CARB Tier III. The Emissions
Compliance Period referred to on the emissions compliance
label indicates the number of operating hours for which the
engine has shown to meet Federal and Californian emission
requirements. Category C = 50 hours, B = 125 hours, and A
= 300 hours.
WARNING! Long-term exposure to noise
can result in permanent hearing
impairment. So always use approved
hearing protection.
WARNING! Under no circumstances may
the design of the machine be modified
without the permission of the manufacturer.
Always use genuine accessories. Non-
authorized modifications and/or
accessories can result in serious personal
injury or the death of the operator or others.
Your warranty may not cover damage or
liability caused by the use of non-
authorized accessories or replacement
parts.
WARNING! A clearing saw, brushcutter or
trimmer can be dangerous if used
incorrectly or carelessly, and can cause
serious or fatal injury to the operator or
others. It is extremely important that you
read and understand the contents of this
operator's manual.
–
English 27