Makita MU01 Manuel D'instruction page 14

1
010909
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the
base plate of the shear blades is set in place.
1
010910
Tighten two screws with a coin or similars firmly.
1
2
010911
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
010912
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
1. Bent part of the
base plate of
shear blades
1. Screws
1. Locking lever
2. Undercover
on the
on the locking
on
14
1
2
010913
At this time, make sure that the locking lever fits in the
groove in the undercover.
CAUTION:
Never use the tool without installing the undercover
•
on it.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
Removing the hedge shear blades
1
010890
CAUTION:
Install the blade cover before removing or installing
•
the shear blades.
Reverse the tool.
1
4
010891
To remove the shear blades, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
1. Groove in the
undercover
2. Locking lever
1. Blade cover
1. Undercover
2
2. Locking lever
3. Press
3
4. Turn
on the undercover
on the locking lever.