Publicité
Les langues disponibles
Les langues disponibles
6
cleaning & maintenance
Before cleaning the refrigerator always unplug the appliance.
Remove the food. Clean the interior of the appliance. Simply remove the shelves, drawers and door compartments to clean
them by hand. Do not clean the interior accessories in the dishwasher. Use warm water and a neutral detergent, such as
baking soda, to prevent any bad smells occurring. Use two tablespoons and a quart liter of warm water. After cleaning, rinse
the interior with clean water and leave the door open to let it air dry for 1 to 2 hours before the power is turned on. Be careful
not to affect the electrical insulation properties when rinsing with water.
For areas that are difficult to clean in the refrigerator, such as narrow gaps or corners, it is recommended to wipe them
regularly with a soft rag, soft brush, etc. When necessary use some auxiliary tools, such as thin sticks (tooth picks), to ensure
no contamination can accumulate in these areas.
Clean the outside of the refrigerator and the door gasket with mild soap and water. Use a soft moist cloth.
We recommend that you dust the back of the appliance and on the floor with a cloth or vacuum cleaner once a year in order
to maintain a good output and low energy consumption.
Do not use hard brushes, cleaning steel wire balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as
alcohol, acetone, oils, etc.), boiling water, acid or alkaline items to clean the refrigerator considering that this may damage
the fridge surface and interior. Boiling water and benzene may deform or damage plastic parts.
DEFROSTING THE FREEZER SECTION
The freezer section of this appliance is free from frost - no-frost.
If used correctly, no ice will be formed.
Dry and cold air is evenly distributed in the freezer and freezer compartments by means of the fan.
Cold air distributed between the shelves will evenly cool all your food, as a result of which humidity and
frost are prevented.
If an ice layer is created after all, defrost the freezer section when the ice layer has reached a thickness
of 3 mm. Remove all products from the freezer section. Store the frozen products on a cool location,
packaged in newspapers and blankets. Remove the plug from the socket and keep the door of the cooler
section closed while defrosting the freezer section.
Defrost the freezer section Defrosting can be accelerated by placing a tray with hot water in the freezer
section. Do not use sharp metal objects to scrape the freezer section clean, use a plastic ice scraper.
Clean and dry the freezer section. Insert the plug in the socket and set the thermostat to the required
setting. Place the frozen products back in the freezer section once it has reached the required
temperature.
Warning Never remove ice with sharp objects, defrosting sprays, a hair dryer, a heater or something
similar. This could lead to unsafe situations and cause irreparable damage to the appliance.
REPLACING THE LED LIGHTING
This appliance is equipped with LED lighting. It can be used for a long time. In case, if the LED lighting is blown, it must be
replaced by a qualified person to avoid any hazard. Contact the Inventum service department.
22
•
English
Publicité
