ResMed AirSense 11 Mode D'emploi page 18

Disassembling
1. Hold the humidifier tub at the top and bottom, press it gently and pull it aw ay from the device.
Note: take care w hen handling the humidifier tub as the humidifier tub may be hot. Allow 10 minutes
for the heater plate and any excess water to cool.
2. Open the humidifier tub and discard any remaining w ater.
3. Pinch the cuff of the air tubing, and gently pull it aw ay from the device.
4. Hold both the cuff of the air tubing and the sw ivel of the mask, then gently pull apart.
5. Locate the outlet connector on the inside of the device and release it by pressing the clip firmly.
6. Remove the outlet connector by pulling it out through the outlet connector socket at the rear of the