Makita DUH501 Manuel D'instruction page 12

► 1 . Hook
NOTICE:
Make sure that the chip receiver does
not overlap the branch catcher.
1
► 1 . Branch catcher
To remove the chip receiver, press the levers on both
sides to release the hooks.
► 1 . Lever
NOTICE:
Never try to remove the chip receiver
by an excessive force with its hooks locked in the
grooves of the shear blades.
OPERATION
WARNING:
blades.
CAUTION:
hot weather as much as practicable. When operat-
ing the tool, be careful of your physical condition.
CAUTION:
1
contact a metal fence or other hard objects while
trimming. The shear blades may break and cause
an injury.
CAUTION:
blades to contact the ground. The tool may recoil
and cause an injury.
CAUTION:
mer, particularly from a ladder, is extremely
dangerous. Do not work while standing on anything
wobbly or infirm.
NOTICE:
than 10 mm (3/8") in diameter with the tool. Cut
branches to 10 cm (4") lower than the cutting height
using branch cutters before using the tool.
► ( 1) Cutting height (2) 10 cm (4")
NOTICE:
hard objects. Doing so may damage the tool.
NOTICE:
using the shear blades. The shear blades may
become tangled in the grass or weeds.
1
12 ENGLISH
Keep hands away from shear
Avoid operating the tool in very
Be careful not to accidentally
Be careful not to allow the shear
Overreaching with a hedge trim-
Do not attempt to cut branches thicker
Do not cut down dead trees or similar
Do not trim the grass or weeds while
(1)
(2)