Wiring Diagram - Whirlpool UXT4230AY Instructions D'installation Et Guide D'utilisation Et D'entretien

For non-vented (recirculating) installations:
The charcoal filter is not washable. It should last up to 6 months
with normal use.
1. Replace metal grease filter with a charcoal filter. For
information on ordering, see the "Accessories" section.
To replace filter:
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
4. Replace screw in the grease filter retainer.
14

WIRING DIAGRAM

Motor Switch
Off - On
NOTE: Speed 1
not used
C25
Motor Characteristics
Power Supply
120 VAC
Frequency
60 Hz
Amperage
1.2 ±10% A
Wattage Rating
73 ±10% Watts
Motor Resistance
White - Red
17.1 ±10% Ohms
White - Black 13.6 ±10% Ohms
Replacing the Incandescent Light Bulb
Turn off the range hood and allow the light bulb to cool.
1. Disconnect power.
2. Squeeze the plastic lens cover and remove it from the hood.
3. Screw light bulb into socket.
4. Replace lens cover by squeezing cover and inserting tabs
into slots.
5. Reconnect power.
If new light does not operate, make sure the lamp is inserted
correctly before calling service.
Lamp Switch
Off - Low - High
1 2
Lamp Switch
1 - 2
1 - 3 Low
L 3
1 - L High
Rectifier
Diode
Ground
Screw
SE114A
N
L
GND
B
A
A. Light bulb socket
B. Lens cover
Operation
Off