Skip Value - Reiner jetStamp 790 Mode D'emploi

jetStamp 790/790 MP
If a second numberer is required, customer-specific imprints in the range from
P : 26 to P : 29 must be selected (see "Selecting imprint", page 70).
Proceed as in Menu access (see page 49).
Press [NEXT] until "MODE NUM 2" appears.
f
Proceed using the same process.

2.1.3. Skip value

The skip value defines the interval in which the numberer counts, e.g. in steps of 3.
Imprint P : 05 to P : 07, P : 11 to P : 14 or P : 20 to P : 25 must be chosen
(see "Selecting imprint", page 70).
Proceed as in Menu access (see page 49).
Press [NEXT] until "SKIP NUM 1" appears.
f
Press [VARY].
f
To increase the number value, press [INC].
f
To decrease the number value, press [DEC].
f
Skip value can be set in the range from 01 to 99.
To save changes and to return to the main menu,
f
press [RETURN] three times.
The main menu appears.
To set the skip value for a second numberer, customer-specific imprints in the range
from P : 26 to P : 29 must be selected (see "Selecting imprint", page 70).
Proceed as in Menu access (see page 49).
Press [NEXT] until "SKIP NUM 2" appears.
f
Proceed using the same process.
GB
65