Publicité
Les langues disponibles
Les langues disponibles
2_WARNING:
ALWAYS use safety gJasses.
Everyday
eye gJasses are NOT safety
glasses.
Also use face or dust mask if cutting
operation is dusty.
ALWAYS
WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection
(CAN/CPA Z94.3),
• ANSI $12.6 ($3.19) hearing protection,
• NOSH/OSHA
respiratory protection.
SYMBOLS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V ..................
volts
Hz................ hertz
min .............. minutes
- - -. ............ direct current
@ ................ Class I Construction
(grounded)
[] ................ Class II Construction
(double insulated)
............ Readinstructionmanual b eforeuse
0 ................ Use proper eye protection
A ................... amperes
W.................. watts
, ................ alternating current
no ................. no load .speed
G. ................. earthing terminal
z_ ................ safety alert symbol
.../min or rpm...revo/utions or
reciprocation per minute
@.................. Use proper respiratory protection
0 .................. Use proper hearing protection
When using an extension cord, be
sure to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. The following table shows
the correct size to use depending on
cord length and nameplate ampere
rating. If in doubt, use the next heavier
gauge. The smaller the gauge number,
the heavier the cord.
Minimum Gauge for Cord Sets
VoJts
Total Length of Cord in Feet
120V
0-25
26-50
51-100
101-150
(0-7,6m)
(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
51-100
101-200
201-300
(0-15,2m) (15,2-30,4m)(30,4-60,9m)(60,9-91,4m)
Ampere Rating
More
Not more
American Wire Gauge
Than
Than
0
-
6
18
16
16
14
6
-
10
18
16
14
12
10 -
12
16
16
14
12
12 -
16
14
12
Not Recommended
FUNCTIONAL
DESCRIPTION
1. Forward/reverse
slider
2. Variable speed trigger
3. Attachment
release button
4. Bit holder
7. Torque adjustment collar
5. Drill/screwdriver
attachment
Double-ended bit tip (not shown)
6. Keyless chuck
Publicité
