Publicité
Les langues disponibles
Les langues disponibles
BOILER ASSEMBLY
1. Remove the ironing station from its packaging and make sure all packing
has been removed (including the protective bags). Put the station on a flat
and solid surface.
2. Unscrew the Safety Cap (1). Fill the boiler with a maximum of 8 cups (1.9
litres) of water for the 5100IS. Use the funnel supplied, making sure you do
not overfill the tank (you can also use the water stick to determine the
water level in the steam tank).
Note:
To preserve the life of your boiler, we recommend distilled water.
Tap water is okay, but more cleaning is required. See maintenance section
for more cleaning information.
How to use the water stick: Fully insert the water stick into the tank. Place
your finger on the end of the water stick. While holding the end, remove
the water stick from the boiler tank. The water level capacity will then
appear on the stick measurement to indicate the level.
IRON ASSEMBLY
1. Remove iron from packaging and ensure all protective bags/outer
packaging has been taken
2. It is recommended to put the iron on the iron pad (supplied), as the p ad
will withstand the temperature of the iron.
3. Insert the two piece Steam Cord Holder (8) into the
boiler and attach the spring on the iron hose to the coil end of the wand.
4. Connect the Iron to the Ilme plug (12) and the Steam Quick Connect (14) on the boiler.
Turn the lock until it clicks to ensure full connection.
.
8
ge on top of the
9
Publicité
