BDS Maschinen MAB 855 Mode D'emploi page 46

Preparation
Safety instructions
Weldon industrial tool holder
46
WARNING
Risk of injury!
►
Do not use damaged, contaminated or worn tools.
►
Only perform tool changing when the machine is switched
off and not moving. Pull the plug out of the mains socket.
►
After inserting, check that the tool is engaged securely.
►
Only use tools, adapter and accessories that match the
machine.
Inserting the tool
‹
Push the MK3/Weldon industrial holder (A or B) into the spin-
dle taper (3) of the machine.
‹
Before inserting, clean the Weldon shank of the tool and the
tool holder.
‹
Loosen both Allen screws in the tool holder (A, B) with the
tool (I) supplied.
‹
Insert the tool into the tool holder (A, B).
NOTE
►
Insert the appropriate ejector pin (C-F) before inserting a
core drill.
‹
Tighten both screws in the tool holder (A, B) with the tool (I)
supplied.
Removing the tool
‹
Loosen both screws in the tool mounting (A, B) using the tool
(I) supplied and remove the tool by pulling it downwards.
MAB 855