SEVERIN CM 9469 Mode D'emploi page 13

heating period, a slight smell may be
emitted. For that reason, adequate
ventilation should be ensured by opening
windows or balcony doors.
∙ Let the appliance cool down afterwards
and clean it as described in the section
Cleaning and care.
Operation
∙ Unwind the power cord completely.
∙ Insert the plug into a suitable wall socket.
∙ Turn the temperature control to the
desired position.
∙ The red main indicator light comes on.
The appliance is now pre-heating.
∙ Once the pre-set operating temperature
has been reached, the red indicator light
goes out.
∙ Put a small amount of the crêpe mix on
the plate, and then use the smoothing
tool to spread out the mix evenly by
swirling it round with a circular motion.
∙ To keep the cooking temperature at
a constant level, the appliance will
periodically switch off and on again as
indicated by the red indicator light.
∙ Let the crêpe cook until the surface is no
longer liquid and it can be moved easily.
∙ Slide the fl ipping tool under the crêpe, lift
it up and turn it over.
∙ Cook the other side for a short time until
done. To check whether it is ready, use
the fl ipping tool to lift it slightly. The crêpe
should be clearly cooked, but should not
be browned; that way it is easy to fold or
roll up.
∙ Remove the crêpe from the plate.
∙ Put your topping or spread onto the crêpe
and fold or roll it.
∙ If the browning level is not to your
satisfaction, use the control to adjust
the temperature before cooking another
crêpe.
∙ If no further crêpes are to be cooked,
turn the temperature control back to its 0
position. Remove the plug from the wall
socket and allow the appliance to cool
down.
Useful tips
∙ The smoothing tool should be moistened
a little to prevent the crêpe mix sticking to
it.
∙ When attempting the fi rst crêpes, it is
advisable to use a little more mix, as
thicker crêpes are easier to handle.
∙ When the crêpe mix is placed onto the
plate, the differences in temperature
and tension may result in some slight
deformation of the plate. This is normal
and no reason for concern.
Using the silicone rings
∙ Prepare the appliance as described in the
section Operation.
∙ Wait for the main indicator light (red) to
go out, and then place the silicone rings
on the crêpe plate; lift up the handle
and only hold the ring by the handle.
Caution: The silicone rings must be
placed with the wider base facing
down.
∙ Spread suitable small amounts of dough
onto the rings.
∙ Once the dough is fi rm, use a suitable
heat-resistant implement (eg a spatula or
the smoothing tool to separate the crêpes
from the silicone ring and turn them over.
13