Green Cell INV15 Mode D'emploi page 9

CAUTION: Remember that the battery or other power
source should have 12V or 24V voltage!
1. If you want to connect the inverter to the battery, red
terminal (marked „+") must be connected with the
battery „plus" using the red cable. The black termi-
nal (marked „-") must be connected with the „minus"
of the battery with the black cable. In case of con-
nection to the cigarette lighter socket, select the ap-
propriate cable and connect in the same way: black
cable with black terminal on the inverter and red with
red terminal.
CAUTION! A reverse polarity connection (positive to
negative) may damage the inverter (Fuse). Damage
caused by the reverse polarity connection will invalida-
te your warranty.
WARNING: Sparking may occur when connecting the
unit to the battery, make sure no flammable fumes or
materials are near before connecting.
2. Tighten the nut on each DC terminal by hand as
much as possible. If the power is higher than 1800W,
please use tools to tight up the screw.
3. Plug the device into the mains or USB port on the
inverter housing.
CAUTION: Do not connect devices with the required po-
wer greater than the inverter power.
4. Start the inverter by setting switch (0/1) to position 1.
5. If the green LED lights up, you can start the connec-
ted devices up.
CAUTION: Remember to start the devices one by one in
short time spaces.
6. If the inverter is not being used, it should be discon-
nected from the power supply.
CAUTION: Before using the inverter, please provide
a ground connection wire. The terminal on the back of
the inverter is placed to connect to a grounded power
outlet. Please choose heavy duty, insulated wire. In
a vehicle, it should be mounted on the chassis. In the
case of a boat, it should be mounted on its grounding
system.
Inverter's Working Status
The green LED light indicates the correct operating sta-
tus of the inverter and the current transmission.
If the low battery voltage alarm turns on, switch off the
inverter immediately.
EN / 9