Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
The engine starts but
stops after a short
time.
To read error codes
The diagnostic tool shows the error codes with a
flashing LED. The error codes is used to identify a
problem with the product. Each error code identifies a
problem. For information about cause and solution, refer
Error codes and descriptions on page 22 .
to
The error code LED flashes multiple times. The number
of times that the error code LED will flash, shows a
number in the error code. Each error code have 4 digits.
There is a 1 second stop between each of the flashes in
an error code. There is a 3 second stop between each
error code. When the error code sequence is complete
the digits 6 and 1 (61) flashes.
1. Make sure that the ON/OFF key is put to the OFF
position.
2. Make sure that the battery voltage is more than 11
volts.
Error codes and descriptions
Error code number
0117
0122
0131
0337
0351
22
Troubleshooting
Cause
The propane tank is almost empty.
Cause
The coolant/oil temperature sensor circuit
has a shorted connection, faulty sensor or
shorted wire.
The throttle position sensor (TPS) has an
open connection, broken wire or faulty
sensor.
The oxygen sensor has an open connec-
tion, broken wire or faulty sensor.
The crankshaft position sensor has no sig-
nal due to air gap incorrect, loose sensor,
open or shorted connection or faulty sen-
sor.
The cylinder 1 Ignition coil Malfunction
due to broken wire in harness (may not
be visible), shorted connection or faulty
sensor.
Solution
Fill or replace the propane tank.
3. Turn the ON/OFF key from the ON position to the
OFF position 2 times continuously.
Note:
Make sure to turn the ON/OFF key
continuously with less than 2.5 seconds between
each turn.
4. Turn the ON/OFF key to the ON position again. Let
the ON/OFF key stay in the ON position.
5. Write down the error codes while they shows.
Note:
When the error code sequence is complete
the digits 6 and 1 (61) flashes
Note:
If the error code 61 shows immediately, that
means that there are no other error codes.
Solution
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
1998 - 002 - 14.12.2023
Publicité
