Publicité
Les langues disponibles
Les langues disponibles
To adjust the angle of the tool
•
Operate the tool angle handle (C) to adjust the angle
of the tool.
C
B
A
Note:
The tool angle handle controls the hydraulic
piston (B) and the angle of the tool holder (A).
To adjust the height of the tool
1. Remove the pin (A).
B
2. Pull out the rod (B).
3. Move the cutting head (C) to the correct position.
4. Install the rod (B).
5. Install the pin (A).
To adjust the engine speed
The throttle control adjusts the engine speed and the
speed of the tool.
12
•
Turn the throttle control counterclockwise (A) to
increase the engine speed. The end position is the
full speed.
•
Turn the throttle control clockwise (B) to decrease
the engine speed. The end position is the idle speed.
To stop the product
1. Park the product in a safe area and on a level
surface. Refer to
11 .
2. Set the movement controls in neutral position.
3. Turn the ON/OFF key counterclockwise to the OFF
position.
4. Release the seat belt.
5. Remove the blade from the product.
To remove a soft floor surface
A
Note:
than blades with a larger width. Blades with a larger
width are not always better or faster. A blade with a
smaller width usually cleans the floor better than a blade
C
with a larger width.
Note:
work area is clean from unwanted material.
1. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
2. Install a self scoring blade. Refer to
blade on page 16 and To replace the blade on
page 16 .
3. Make sure that the blade is sharp. Sharpen the
blade if it is necessary. Refer to
blade on page 17 .
A
To operate the product on page
WARNING:
Use protective gloves
with . The blades are very sharp.
Blades with a smaller width cut the floors easier
The blades are sharp for a longer time if the
B
To replace the
To sharpen the
1998 - 002 - 14.12.2023
Publicité
