Télécharger Imprimer la page

Edy EDTK5508 Mode D'emploi page 50

Publicité

Les langues disponibles

Les langues disponibles

First use and installation
2.Put screw into the hole of rubber
supporting pad.
scr ew
rubber supporting pad
3.Make screw in alignment with the hole on
lower base cover . Fasten rubber supporting
pad to the base cover firmly by a cross
screw driver (self-provided).
cro ss screwdrawer
Leveling
The appliance should be level in order to
eliminate vibration. To make the appliance
level, it should be upright and both
adjusters should be in stable contact with
the floor. You can also adjust the level by
unscrewing the appropriate level
adjustment in the front (use your fingers or
a suitable spanner).
Electrical connection
Caution! Any electrical work required to
install this appliance should be carried out by
qualified or authorized personnel.
Warning! This appliance must be grounded.
The manufacturer declines any liability should
these safety measures not be observed.
This refrigerating appliance is not intended
to be used as a built-in appliance.
10

Publicité

loading