SEAL 62 Pro S Manuel D'utilisation page 39

6.2.1 Auto-grip shafts
Check the auto-grip mechanism on each shaft.
•
The distance (d) between the rubber cords and the edges of the recess should be 8 ± 2.5 mm
minimum (the cord must not touch the skew).
d
A
Figure 22: Auto-grip shaft
If not, correct as follows:
•
Loosen the clamp (2) with the screw (1) until the cord is free on one side,
•
Shorten the cord by approximately 10 mm (0.4 in.),
•
Put the end of the cord back underneath the clamp (2),
•
Secure it by tightening the screw (1).
6.3 Trouble shooting
During processing wrinkles can show up in the image (1) on the in-feed table (2) and in the process
result (4) on the output table. The figures below show some examples where it is caused by the
main rollers (3) and gives a possible solution.
Wait until a few meters is processed to see results.
Pressure too high.
Figure 23: Wrinkles due to high pressure.
•
Decrease the roller pressure a little (5-10%).
Pressure too low.
Figure 24: Wrinkles due to low pressure.
Maintenance
3 2 1
B
31