5 OPERATING
This chapter describes the function of the controls and indicators, the operating modes, how to set
up and operate the machine and a number of applications.
The sections in this chapter are placed in a sequence in which the information is needed for
laminating processes.
For the mounting process the sections 5.3 and 5.4 can be skipped with the exception of setting the
pressure (see section 5.3.6).
5.1 Process controls
This section gives an overview of the functions of the controls on the control panel
(Figure 9), the heater control (Figure 10) and elsewhere on the machine (Figure 11).
Note:
Switch on the heaters approximately 1 hour before use, if a process requires the rollers to be
heated. Close the nip and let the machine run at low speed, to avoid uneven hot spots.
5.1.1 Control panel
This paragraph describes the controls and indicators on the control panel.
When LED's are blinking, this indicates an error. Refer to 5.1.4 for their meaning.
Figure 9: Control panel
Operating
13