LENCO CD-300 Mode D'emploi page 7

2. FUNCTION
Setup
2. Using a USB-DC cable (included), connect the USB plug to the USB power adaptor
3. Connect the DC plug into the DC IN port of the unit. The unit will now charge.
4. The CHARGE indicator will be light on when unit start charging.
5. The red CHARGE indicator light o means fully charged. When charging is completed, remove the
DC plug from main unit.
Connect power adapter (not included) for AC power
This unit can also be powered using an AC adapter (not included) with an input voltage of AC 220V-240V
50Hz, and output voltage of DC 5 minimum 1000mA
1. Connect small end of power adapter to your unit DC input jack and plug the adapter body to AC
outlet carefully.
Connect Ear phone for unit sound output
Install the ear phone to your unit follow the figure.
AA / LR6 /UM-3
AA / LR6 /UM-3
Connect to phone jack of main unit
7
Carefully pushing the
one lug down that the
the battery door can
be lifted away.