Warnings For Installers - Urmet Mininote+ Mikra2 1722/95 Manuel D'installation

6.

WARNINGS FOR INSTALLERS

Read the notes in this manual carefully. This manual contains important information on safe installation, use
and maintenance.
• This devices in the kit must only be put to the use for which they were intended. All other use is
improper. The manufacturer cannot be held responsible for damage deriving from improper, incorrect
or unreasonable use.
• Each part was designed to be compliant with the standards in force.
• The system must be built in compliance with the regulations in force. All devices in the system must be
exclusively used for the purpose for which they were designed.
• Remove the components from the packaging and check that they are intact.
• Keep the packaging (plastic bags, polystyrene, etc.) away from children. Packaging is potentially
dangerous.
• Provide a suitable cut-off and protection master switch upstream from the devices, with contacts open
by at least 3 mm.
• Make sure that the plate data corresponds to the power specifi cations before connecting the devices
to the mains.
• Keep the ventilation or cooling openings and slots free.
• Disconnect the devices from the mains before cleaning or maintenance.
• Do not use spray products to clean the device.
• Disconnect power from the circuit breaker in the event of failure and/or malfunctioning of the products
contained in the kit. Do not tamper with the devices.
• Exclusively contact a service centre authorised by the manufacturer for repairs.
• Provide suitable ventilation.
• Do not use power extension wires.
• Have the device checked and repaired by qualifi ed personnel in the case of infi ltration of fl uid or objects
inside the device.
• Exclusively use the spare parts supplied by the manufacturer for repairs.
• Installers must make sure that user's information is applied to the connected devices.
• Disrespect of these precautions can effect safety of the devices.
• Keep this manual with the device at all times.
• The lightening symbol in a equilateral triangle indicates the presence of dangerous voltage.
• Never open the devices unless expressly instructed to do so in this instruction manual.
• The exclamation mark symbol in an equilateral triangle indicates critical safety components. Always
only use components supplied by the manufacturer.
26
DS1722-125