Cautions; General Warnings; Installation Precautions; Cleaning The Parts - Urmet 956/81 Manuel D'installation Et D'utilisation

1

CAUTIONS

Read the notes in this manual carefully. This manual contains important information on safe installation,
use and maintenance.
1.1

GENERAL WARNINGS

This device is only intended for the specifically designed use.
•
All other use is improper. The manufacturer cannot be held responsible for damage deriving from
•
improper, incorrect or unreasonable use.
The system must be built in compliance with the regulations in force. All devices in the system must
•
be exclusively used for the purpose for which they were designed.
Provide a suitable cut-off and protection master switch upstream from the devices, with contacts open
•
by at least 3 mm.
Make sure that the plate data corresponds to the power specifications before connecting the device to
•
the mains.
Check that the device is intact after removing it from the packaging.
•
Keep the packaging (plastic bags, polystyrene etc.) away from children. Packaging is potentially
•
dangerous.
Keep the ventilation or cooling openings and slots free.
•
Do not install the device in environments exposed to rain or humidity. Use specific boxes if required.
•
Disconnect the device from the mains by means of the system switch before cleaning or maintenance.
•
Disconnect power from the circuit breaker in the event of failure and/or malfunctioning of the device.
•
Do not tamper with the device.
Exclusively contact a service centre authorised by the manufacturer for repairs and in case of
•
infiltration of fluid or objects inside the device.
Do not use power extension wires.
•
Exclusively use the spare parts supplied by the manufacturer.
•
Installers must make sure that user's information is applied to the connected devices.
•
Disrespect of these precautions can affect safety of the device.
•
Keep this manual with the device at all times.
•
The information contained in this manual is subject to change without prior notice.
•
1.2

INSTALLATION PRECAUTIONS

This kit must be powered using the specific power supply included in the kit.
•
Position the components as shown on vertical, smooth supports respecting the instructions contained
•
in this manual.
Holding the electric lock opening button pressed could damage the lock.
•
1.3

CLEANING THE PARTS

Use a soft cloth to remove dust and dirt.
•
Do not use aggressive detergent liquids (petrol, solvents etc.) which could cause corrosion.
•
Do not use spray products to clean the device.
•
16 DS956-011A