Zanussi ZDLN7531 Notice D'utilisation page 14

USING THE DETERGENT
A B
C
CAUTION! Only use detergent
specifically designed for dishwashers.
1. Press the release button (A) to open the lid (C).
2. Put the detergent, in powder or tablets, in the
compartment (B).
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the lid locks into
position.
HOW TO SELECT AND START A
PROGRAMME
1. Press the button dedicated to the programme
you want to set.
• The light related to the button is on.
• The display shows the programme duration.
2. Activate applicable options if desired.
3. Close the appliance door to start the
programme.
HOW TO SELECT AND START THE
PROGRAMME PRE-RINSE
1. To select Pre-rinse, press and hold 30 min for
3 seconds.
• The light related to the button is on.
• The display shows the programme duration.
Options are not applicable to this
programme.
2. Close the appliance door to start the
programme.
HOW TO ACTIVATE OPTIONS
1. Select a programme.
2. Press the button dedicated to the option you
want to activate.
14
• The light related to the button is on.
• The display shows the updated programme
duration.
By default, options must be activated
every time before you start a
programme.
If the latest programme selection is
enabled, the saved options are
activated automatically along with the
programme.
It is not possible to activate or
deactivate options while a programme
is running.
Not all options are compatible with
each other.
Activating options often increases the
water and energy consumption as well
as the programme duration.
HOW TO SELECT AND START THE
PROGRAMME AUTO
1. Press AUTO.
• The light related to the button is on.
• The display shows the programme duration.
Options are not applicable to this
programme.
2. Close the appliance door to start the
programme.
The appliance senses the type of load and adjusts
a suitable wash cycle. During the cycle, the sensors
operate several times and the initial programme
duration can decrease.
HOW TO DELAY THE START OF A
PROGRAMME
1. Select a programme.
2. Press repeatedly until the display shows
the desired delay time (from 1 to 24 hours).
The light related to the button is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to change
the delay time and the programme selection.
When the countdown is complete, the programme
starts.
HOW TO CANCEL THE DELAY START WHILE
THE COUNTDOWN OPERATES