Varan Motors NEGJH-04 Manuel D'utilisation page 38

• A reaction movement may occur on the accessory when
stones or soil.
Always firmly hold the machine in order to control such a movement.
• Take regular breaks. Consider that the tool is heavy, which increases fatigue.
• Begin working with the speed throttle lever at low speed so you can easily control the tool and then increase the
speed gradually.
• Never attempt to break too big items. Adjust the frequency of breaks to prevent the tool from getting blocked.
• If the tool jams, never try to release it by pulling on the top of the tank.
• When the accessory is stuck in the material and cannot be released, stop the engine (wait for it to cool down) and
remove the spark plug, then remove the accessory from the chuck so as not to damage the tool. Try to remove the
accessory using spread wedge, a hammer ... if the accessory gets damaged, do NOT reuse it.
Work chiseling / flaking / demolition
Hold the tool firmly with both hands.
Start engine and apply a slight
jumping from one side to the other.
The application of a high pressure on the tool does not increase its efficiency.
MAINTENANCE, STORAGE AND TROUBLESHOOTING
• Before cleaning, the inspecting or repairing the unit, make sure that engine has stopped and cooled down.
Disconnect the spark plug to prevent accidental starting.
• Always use protective gloves when inspecting, removing or installing the bit.
• Do not modify the drill and do not disassemble the engine.
• When replacing parts, use of authorized parts
Reminder: Make sure to maintain the machine in good working condition, carry out regular maintenance of the
machine after each use and before storage.
Any breach or default of adequate maintenance reduces the life of the machine and increases the risk
of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform
maintenance and proper cleaning, DO NOT use non-compliant replacement parts and do NOT
dismantle yourself the machine or change the security features.
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
downward pressure on the tool so as to maintain its control and prevent it from
NEGJH-04
the impacting accessory strikes hard
WARNING
T: 00352/26908036 – F: 00352/26908040