Intended Use; Working With The Machine - Varan Motors NEGJH-04 Manuel D'utilisation

Progressively start the machine, do not accelerate quickly.
Remark : To restart a warm engine
If the fuel tank is not empty, pull recoil starter cord 1 to 3 times, until engine starts. If the fuel tank
is emptied, refuel accordingly and repeat above steps 5 to 7.
Note: Always warm up engine before operation
Note : When restarting the engine immediately after stopping it, leave the choke open
Note: in cold weather or when the tool has not been used for a prolonged period of time, let the engine warm up
for a while by running it without load. This will allow the lubricant to warm up. The hammering will be difficult if the
tool is not properly warmed up.
Stopping the machine
1.
Release the throttle and let engine run idle for 3-5 minutes.
2.
Press the red button (17) to stop engine.
ATTENTION ! - Warm up the engine with the accessory (bit) already fitted in
OPERATION

Intended use

The product is intended for work on the ground with a suitable accessory. The product is
not intended to drilling for water, oil, gas ... for cutting.
Do not use the product for uses/ applications not described in this manual.
Avoid working on extremely hard materials such as granite and metals, as this leads to substantial vibrations.
Do NOT use tool without a mounted accessory.
Operation
Before use, ensure to check the following:
1.
Check that fasteners are not loose (ex. screws, nuts, ...)
2.
Check that the air filter is not dirty. If deemed necessary, clean the air filter before use.
3.
Check that there are no fuel leaks.
4.
Use only suitable accessories (e.g flat, chisel, pointed chisel...)
5.
Check that the accessory does turn when engine runs idle. WARNING:
do NOT tolerate any person in the work area and within 15m (i.e the
called "danger zone").
Note: become familiar with the operation of the product by working on
a small area in good working conditions.
6.
Make sure the area or work area does not have: liquids or
flammable or explosive materials, underground
cables or pipes.

Working with the machine

correct working position Fig.5b:
Incorrect working position
• Always hold the tool firmly with both hands encircling the grips handles (14).
• Hold the body (feet, leg) at a certain distance of the accessory.
• Keep the accessory to a slight angle (5-8°) relative to the work plan.
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
- Remain away from accessory during operation
Fig.5a:
NEGJH-04
T: 00352/26908036 – F: 00352/26908040