Operation; Standby Mode; Standby With No Transmitter Programmed; Standby With At Least One Transmitter Programmed - Bosch LE10 Manuel D'utilisation

40 en | Operation
6

Operation

6.1

Standby mode

The LE10 Radio Receiver enters standby mode when the power
supply is connected. Both relays are off. See Section 4.2.1 Mode
indication after power on, page 36.
6.1.1

Standby with no transmitter programmed

Device behavior
–
–
6.1.2

Standby with at least one transmitter programmed

Device behavior
–
–
6.2

Normal mode (modes 1 and 2)

6.2.1

Activation of a transmitter in normal mode

Device behavior
–
When a matched transmitter is activated:
–
–
–
If the same or another matched transmitter is activated within
10 seconds, the alarm will be retriggered for 10 seconds.
Device behavior when a transmitter has a low battery
–
When the transmitter is activated:
–
–
F.01U.139.675 | V1 | 2009.10
LED 1 stays permanently green.
LED 2 blinks 3 times red every 10 seconds.
LED 1 stays permanently green.
LED 2 stays permanently off.
LED 1 stays permanently green.
LED 2 lights up permanently red for 10 seconds.
Relay 1 switches on for 10 seconds.
Relay 2 stays off.
LED 1 stays permanently green.
LED 2 blinks red twice for 2 seconds, then lights up
permanently for 8 seconds. It then blinks once every 10
seconds.
Relay 1 switches on for 10 seconds.
User Manual
LE10 Radio Receiver
Bosch Security Systems