Mode Selection; Mode Indication After Power On - Bosch LE10 Manuel D'utilisation

36 en | Connection compartment
4.2

Mode selection

Modes 1 to 7 can be selected by operating switches 1 to 3 of
the 5-digits micro switch S3. Switches 4 and 5 must be set to
off.
CAUTION!
After selecting the mode, disconnect the power supply and
connect it again.
Mode Description
1
2
3
4
5
6
7
NOTICE!
Factory setting is all switches set to off.
4.2.1

Mode indication after power on

When the power supply is connected to the LE10 Radio
Receiver, the LED 1 will light up permanently for 2 seconds.
Afterwards, the device will display the current mode through
the LED 1, by blinking as many times as the number of the
mode. LED 1 will then light up permanently.
For example, in mode 2, the LED 1 will blink green twice.
F.01U.139.675 | V1 | 2009.10
Normal mode
Normal mode, with LED 2
deactivated at battery-low
indication
Dementia mode
Dementia with Accompany
mode
Remote control
Open receiver
Open receiver with reduced
range
User Manual
LE10 Radio Receiver
Switch Switch
1 2
off off
on off
off on
on on
off off
on off
off on
Bosch Security Systems
Switch
3
off
off
off
off
on
on
on