Homelite UT44180 Manuel D'utilisation page 10

UNPAcKINg
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNINg:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-242-4672 for assistance.
PAcKINg LIST
Hedge Trimmer
Debris Deflector
Scabbard
Operator's Manual
WARNINg:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
ASSEMBLy
WARNINg:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNINg:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
ASSEMBLINg ThE TOOL
See Figures 3 - 4.
 Remove and discard the wire harness protectors from
the upper and lower tubes.
 Rotating the threaded collar counterclockwise, unscrew
the collar then pull the collar back over the wire harness
to the upper tube.
 Insert the upper tube into the lower tube until the tubes
click into place (the tubes will only install one way).
NOTE: The threaded base will spread open during
assembly; slightly rotate tube from side to side until it
locks into place.
 Slide the threaded collar onto the threaded base and turn
the collar clockwise. Tighten securely.
NOTE: Once assembled correctly, the upper and lower tubes
should not separate when pulled. Repeat above steps if
tubes can be separated.
WARNINg:
Failure to secure the upper tube to the lower tube as
instructed above could result in serious injury or death.
Page 8 — English