Understanding Your Training System - Zolux 487043 Guide D'utilisation

UNDERSTANDING YOUR TRAINING SYSTEM

FR
1/ How to Turn the Unit On
and Off
EN
To activate the receiver/collar,
place the red dot on the back of
PL
the handheld transmitter to the
red dot on the receiver/collar.
NL
Hold the two red dots together
for a moment until the LED light
ES
on the receiver/collar comes on.
To deactivate the unit, repeat
PT the same procedure, holding the two red dots together momentarily. The LED light will turn red
for a brief moment indicating that the receiver/collar is now shut off. The transmitter does not
have an on/off switch, and it will only activate when the buttons are pressed.
2/ How the Buttons Work
Stimulation is sent to the receiver/collar by pressing one of the buttons on the handheld
transmitter. The number on the button controls the corresponding receiver/collar.
When a button is pressed, the LED will illuminate on the handheld transmitter and the
corresponding receiver/collar.
3/ How to Fit the Collar on the Dog
The collar should be fitted so that the Conductive Plastic Contact Points press firmly against the
dog's skin. When properly fitted, you should be able to fit a finger or two snugly in between the
contact points and your dog's skin. When properly fitted, the
receiver/collar should not move on the dog. The best location for
the receiver/collar box is off to either side of the dog's
windpipe. A loose fit can allow the receiver/collar to move
around on the dog's neck. When this happens, the contact
points may rub the skin and cause irritation. If the collar is
too tight, the dog may have difficulty breathing.
14
Button 1 - Dog 1 Stimulation Button: When the Dog 1 Stimulation
Button is pressed, the corresponding receiver/collar will receive a
momentary burst of stimulation. Holding down this button will send a
pulsating stimulation for up to 5 seconds. The stimulation will
automatically shut off when the button is depressed for more than 5
seconds.
Button 2 – Dog 2 Stimulation Button: Not available