Roborock Dyad Pro Combo Manuel D'utilisation page 12

Cleaning the Charging
E4
Dock Tray
E4-1— Grasp the side handles of the tray and
pull upward.
E4-2— Rinse the tray with water and reinstall it
in place after drying.
E4-3— Note: Only remove and wash the tray. Do
not wash any other parts of the charging
dock.
Cleaning the Main Unit and
E5
Dustbin Combo Unit
E5-1— To discard the dust, press the dustbin
release button and remove the dustbin.
E5-2— Remove the filter.
E5-3— Grab the handle and lift out the cyclone
parts.
E5-4— Discard the dust inside and install the
cyclone parts and filter back into the
dustbin.
E5-5—
Do not wash the dustbin to avoid
damaging the electrical parts inside.
Cleaning the Multi-Surface
E6
Brush
E6-1— Turn the brush head over with the
bottom facing you. Look for debris,
including hair and fibers on the head or
in the bearings.
E6-2— Cut off any hair entangled on the
roller and remove any debris using the
provided maintenance brush.
Note: Use the maintenance brush carefully to avoid injury.
Cleaning the Motorized
E7
Mini-Brush
E7-1— Hold the brush so the lock on the
side is facing you, and turn the lock
counterclockwise.
E7-2— After removing the locking mechanism,
remove the roller.
E7-3— Clean the roller with the maintenance
brush provided and then wash the roller.
E7-4— Place the roller vertically and dry it for at
least 24 hours for it to dry thoroughly.
Note: Use the maintenance brush carefully to avoid injury.
11
Basic Parameters
Main Unit
Model H1C1A
Rated Input 25.75V 1A
21.6 V/4000 mAh (TYP)
Battery
Lithium-ion battery
Dock Charger
MDS01LRR or
Model
MDS02LRR
Rated Input
120V~
Voltage
Rated
60Hz
Frequency
Rated Input 1A
Rated Output 25.75V 1A
21.6 V/4000 mAh (TYP)
Battery
Lithium-ion battery