Panasonic KX-PRWA13C Manuel D'installation page 4

Installation
Registering a handset to a base unit
1
Handset:
Lift the handset and press MOFFN.
2
Base unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop,
3
Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
Note:
R If an error tone sounds, or if
the base unit's operating instructions.
Display language
1
MMenuN (right soft key) #110
2
MbN: Select the desired setting. a MSaveN a MOFFN
For your safety
To prevent severe injury and loss of life/property, read this section carefully before
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
R Completely insert the AC adaptor/power plug into the power outlet. Failure to do
so may cause electric shock and/or excessive heat resulting in a fire.
R Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a fire.
R Unplug the product from power outlets if it emits smoke, an abnormal smell, or
makes an unusual noise. These conditions can cause fire or electric shock.
Confirm that smoke has stopped emitting and contact us by visiting our support
page on: www.panasonic.ca
4
PRWA13C(en)_1211_ver011.pdf PRWA13C(en)_1211_ver011.pdf
then repeat this step.
is displayed.
4 4
is displayed, register the handset according to
2013/12/11 2013/12/11 20:41:53 20:41:53