Publicité
Les langues disponibles
Les langues disponibles
4.
Install the lower case on the switch box or directly on the wall.
When using the switch box
Switch box for two units
Seal the remote control cord
lead-in hole with putty
(See 2 above)
CAUTION Do not tighten the screws too tight. Doing so may deform or crack the lower cover.
NOTE: - Chose a flat plane for installation.
- Fasten the switch box at more than two places when installing directly on the wall.
- When reinstalling on the wall, fasten securely using anchors.
5.
Connect the remote control cord to the remote controller terminal block.
Do not use crimp terminals to connect to the remote controller terminal block. To do so may cause the terminals to touch the
CAUTION
board and cause trouble at the remote controller. If the terminals touch the cover, the cover may be damaged.
6.
Set the remote controller address using the rotary switches.
Rotary switches
10 digit
(Left)
(Ex: Address 108)
7.
Wiring hole for installing directly on the wall (or open wiring)
• Cut off the shaded area from the upper cover using a knife, nippers, etc.
• Take out the remote control cord connected to the terminal block via this portion.
8.
Install the cover to the remote controller.
First, hook the cover to the two upper claws and then fit it to the remote controller.
CAUTION Press the cover until it snaps shut. If not, it may fall off.
NOTE: A protection sheet is stuck to the operation section. Peel off this protection sheet before use.
9.
Affix a caution label.
A caution label in English is supplied on the back surface of the control panel door. Affix another caution label in the language of a country where
you use the remote control over the English one.
5
How To Connect Optional Parts
•
When connecting a Program timer, connect a 5-core cable to the connector on the remote controller. (A
5-core cable is supplied with the Program timer.)
•
To route the cable, cut off the thin-wall portion.
•
For wiring path convenience, install the Program timer to the left-hand side of the remote controller.
When expansion is expected, take into consideration remote controller space at the left-hand side.
For the operation method details, refer to the Program timer installation manual.
Remote control cord
(See 5 below)
Master remote controller
Subordiate remote
controller
1 digit
Rotary switch setting
(Right)
01 to 99
00
CAUTION
NOTE: - Address No. 101 to 200 can be set with the ME remote controller. When set to "01 to
99", the 100 digit is set to [1] and when set to "00", the 100 digit is automatically fixed
at [2].
- The rotary switches are factory set to 01.
Cross recessed pan
head screw
To indoor unit terminal
block TB5
There is no polarity.
Address setting range
101 to 150
151 to 200
101 to 199 (to which 100 is added)
- When setting the address, use a precision screwdriver [(–), 2.0 mm (1/16 in)
(W)] and apply a load of 19.6 N or less.
- If performed any other way, the rotary switch may be destroyed.
When installing directly on the wall
Remote control cord
(See 5 below)
Wood screw
AB
How to set
Set to lowest unit address No. in same
group + 100
Set to lowest unit address No. in same
group + 150
Address No.
200
Program timer connector
4
Publicité
