Setting The Transmission Channel - Monacor International JTS TG-10STX/1 Mode D'emploi

control panel of a conference system, to the
mono input CH 3 (6 3 mm jack, unbal )
5) Connect the power supply unit provided to the
power supply jack (10), then connect it to a
mains socket (230 V / 50 Hz)
5 Operation
Always turn back all volume controls completely
before operating the transmitter
1) Switch on the transmitter [press the button
POWER (2)] and switch on the receiver / receiv-
ers TG-10R /1 The display (3) of the transmitter
shows the transmission channel adjusted (b)
Set the transmitter and all receivers of the sys-
tem to the same transmission channel: Setting
the channel on the transmitter
setting the channel on the receiver
of the receiver
2) Feed the audio signal to be transmitted to the
input Adjust the level with the corresponding
volume control (5): control CH 1 for the signal
at the input CH 1 IN, control CH 2 for the signal
at the input CH 2 IN If you use both inputs, use
the controls to mix the signals as desired If you
only use one of the inputs, completely turn back
the control of the input not used
The corresponding row of LEDs AUDIO
LEVEL (a) shows the level adjusted There is an
optimum level control when the orange LED
lights up with signal peaks In case of overload,
the red LED lights permanently In this case, turn
back the corresponding control accordingly
3) Each receiver TG-10R /1 features a control for in-
dividual adjustment of the reproduction volume
4) To switch off the transmitter after operation,
briefly keep the button POWER (2) pressed until
the display indications are extinguished Remem-
ber to switch off each receiver TG-10R /1 to save
the battery
If the transmitter is not in use for a longer
period of time, disconnect the power supply unit
of the transmitter from the mains socket Even
when the transmitter is switched off, the power
supply unit has a low power consumption
10

5.1 Setting the transmission channel

For wireless transmission, 16 channels
available (channel assignment
set the channel, use the buttons SET, + and − (4):
1) Keep the button SET pressed until the dot next
2) Select the channel with the button + (up) or
3) Press the button SET to confirm The dot next
Note: Interference may be caused by other local wireless
transmitters Therefore, when selecting the transmission
channel, set a channel on the receiver before switching
on the transmitter If no interfering signals are received
on this channel, it is suitable for transmission
☞ chapter 5 1,
☞ manual
5.2 Monitoring the signals via
When headphones are connected to the jack (6),
it is possible to monitor either the transmission
signal or the signal of the audio source at the input
CH 3 (8) [
mono signal selected is fed to the left channel and
the right channel of the stereo headphones
The headphones are operated via the knob "Mon-
itor Selector" (7) which is both a selector switch
and a volume control:
1) To select the monitor signal for the headphones,
2) To adjust the headphone volume, turn up the
to the channel indication (b) starts flashing
− (down)
to the channel indication starts flashing rapidly
before it stops flashing
headphones
☞
chapter 4, step 4] The corresponding
briefly press the knob The corresponding LED of
the indication "Monitor" (c) lights up:
– If you select the transmission signal (mixed
signal CH 1/ CH 2), the LED "CH 1/ CH 2" lights
up
– If you select the input signal of CH 3, the LED
"CH 3" lights up
knob as desired
CAUTION Never adjust a very high volume
Permanent high volumes may
damage your hearing! Your ear
will get accustomed to high vol-
umes which do not seem to be
that high after some time There-
fore, do not further increase a
high volume after getting used
to it
to are
☞
chapter 6 2) To