Publicité
Les langues disponibles
Les langues disponibles
Section 01
BAT TERY POWERED IGNITION
Model 1836
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignitor button does not result in a clicking sound
S T E P 0 3
With the help of another person, place the griddle on its
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
wheels. Use one (1) M6x62 screw and one (1) M6 nut to attach the propane
minutes and repeat the lighting procedure.
tank hanger to the left leg assembly.
Install the four (4) control knobs by pushing them into place in the OFF posi-
If this does not work, to determine the cause, please try to ignite your griddle
tion. Insert one (1) AA battery (not included) under the ignition button.
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Ignitor wire misaligned.
04. Damage to the ignition system.
S T E P 0 4
Install the right side
shelf on the griddle body by sliding
If you CAN NOT ignite your griddle with a match
it in place and tightening two (2)
of the small thumb screws to lock
POSSIBLE CAUSES
it in place.
05. Burner tubes are not receiving fuel.
S T E P 0 5
Use four (4) M6x12
screws to install the handle to the
griddle body.
SOLUTION
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
SOLUTION
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Assembly Guide
| Owner's Manual
!
WA r n I n G
Do not touch the handle
while cooking.
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
3-7mm
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
07
Publicité
