Danfoss VLT Micro Drive FC 51 Guide Rapide page 24

Quick Guide
1 1
1.7 Speci cations
1.7.1 Mains Supply 1x200–240 V AC
Normal overload 150% for 1 minute
Frequency converter
Typical shaft output [kW]
Typical shaft output [hp]
Enclosure protection rating IP20
Output current
Continuous (1x200–240 V AC) [A]
Intermittent (1x200–240 V AC) [A]
Maximum cable size:
(Mains, motor) [mm
Maximum input current
Continuous (1x200–240 V) [A]
Intermittent (1x200–240 V) [A]
Maximum mains fuses [A]
Environment
Estimated power loss [W],
Best case/typical
Weight enclosure IP20 [kg]
E ciency [%],
Best case/typical
Table 1.6 Mains Supply 1x200–240 V AC
1) Applies for dimensioning of frequency converter cooling. If the switching frequency is higher than the default setting, the power losses may
increase. LCP and typical control card power consumptions are included. For power loss data according to EN 50598-2, refer to www.danfoss.com/
vltenergye ciency.
2) E ciency measured at nominal current. For energy e ciency class, see chapter 1.8.1 Surroundings. For part load losses, see www.danfoss.com/
vltenergye ciency.
22
VLT
2
/AWG]
1)
2)
Danfoss A/S © 05/2016 All rights reserved.
®
Micro Drive FC 51
PK18
0.18
0.25
M1
1.2
1.8
3.3
4.5
12.5/
15.5
1.1
95.6/
94.5
PK37 PK75 P1K5
0.37 0.75 1.5
0.5 1 2
M1 M1 M2
2.2 4.2 6.8
3.3 6.3 10.2
4/10
6.1 11.6 18.7
8.3 15.6 26.4
See chapter 1.3.3 Fuses
20.0/ 36.5/ 61.0/
25.0 44.0 67.0
1.1 1.1 1.6
96.5/ 96.6/ 97.0/
95.6 96.0 96.7
P2K2
2.2
3
M3
9.6
14.4
26.4
37.0
81.0/
85.1
3.0
96.9/
97.1
MG02BB4P