Kuppersbusch DW9310.0E Instructions D'utilisation page 12

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in the
diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure
that a steady air flow has been established
before fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking
(between 3 to 5 minutes) in order to expel all
the grease from the outlet duct. This prevents
the return of grease, smoke and smells.
Program the working time
Proceed as follows:
1.- Choose the required speed.
2.- Press "timer". The light will begin to flash.
3.-The duration of the "timer" is 10 min.
4.-During the programmed time, fan speed
can be changed.
The intensive speed is autoprogramed and
will change to speed 2 after approximately
10 minutes.
Cleaning and maintenance
During cleaning and maintenance work,
make sure the safety instructions are
complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned in
the product instructions.
• If your kitchen hood is painted, use lukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Dry the kitchen hood using a cloth that does
not produce fibres.
• Do not use vapour cleaners.
• To remove the filters from their fittings,
press lightly on the locks and then pull them
off.
Cleaning the metal filters
• To remove the filters from their fittings,
press lightly on the locks and then pull them
off.
• The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher.
In this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
• Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
• Once clean, leave them to dry off and then
fit them onto the kitchen hood.
Changing light bulbs
Proceed as follows:
•Unscrew the lamp cover.
•Change the broken / burnt out lamp.
•Screw the lamp cover back in.