Sharp SJF790STSL Mode D'emploi page 6

OPERATION
Controlling Temperature
The refrigerator controls its temperature automatically. However, if needed, adjust the temperature as follows.
Refrigerator compartment
1
Press the CHOOSE button and make the R lamp to light.
2
Press the / button and select the desired temperature.
[ : increase, : decrease ]
3
Press the " " button.
Adjustable between 0°C and 6°C in steps of 1°C.
When the refrigerator provides excessive cooling.
When the refrigerator provides excessive cooling.
For keeping foods fresher tasting. When the
refrigerator does not provide sufficient cooling.
Deodorizing unit
A built-in unit which requires no manual operation because it
automatically starts operating when the refrigerator is powered
on.
Defrosting
• The defrosting system incorporates a fully automatic energy
efficient defrosting system.
• The defrost water collects in the evaporating pan, where it is
evaporated by the heat of the compressor, etc.
• The evaporating pan does not require cleaning or
maintenance.
6
Lighting
Freezer compartment
1
Press the CHOOSE button and make the F lamp to light.
Lighting
2
Press the / button and select the desired temperature.
[ : increase, : decrease ]
3
Press the " " button.
Adjustable between -13°C and -21°C in steps of 1°C.
When frozen food or ice cream is not stored.
For normal freezing.
For making ice rapidly or fast freezing.
Door Alarm
When the refrigerator or freezer door is left open, the door
alarm will sound.
• The door alarm will sound 1 minute after opening the door and
again after 1 minute (once in each case).
• If the door is left open for approx. 3 minutes, the alarm will
sound continuously.
To cancel operation
Press the " " button continuously 3 seconds or more while
holding down the CHOOSE button.
It shows the door alarm stop.
It is the same method also when restarting the operation.