Black & Decker BDCDE120 Mode D'emploi page 7

heard (figure B). Ensure battery pack is
fully seated and fully latched into position.
TO rEmOvE BATTErY pACk: Depress
the battery release button (6) as shown in
figure c and pull battery pack out of tool.
B
c
oPeraTInG InSTrucTIonS
TrIGGer SwITcH & reverSInG
BuTTon (fIGure d)
• The drill is turned ON and OFF by pulling
and releasing the trigger switch (1). The
farther the trigger is depressed, the higher
the speed of the drill.
• A forward/reverse control button (2)
determines the direction of the tool and
also serves as a lock off button.
• To select forward rotation, release the trigger
switch and depress the forward/reverse
control button to the left.
• To select reverse, depress the forward/
reverse control button the opposite
direction.
noTe: The center position of the control
button locks the tool in the off position.
When changing the position of the control
button, be sure the trigger is released.
d
2
1
drIll / drIve Mode SelecT (fIGure e)
This drill is equiped with mode select
buttons (3) to quickly and easily change
the performance of the tool to drilling or
driving based upon your project.
• To set the tool to drive mode, press the
button marked with the
• To set the tool to drill mode, press the
button marked with the
noTe: A blue LED will light the symbol for
the mode that is selected.
auToSenSe
This tool is equipped with AUTOSENSE
technology that automatically stops most
screws flush.
• Ensure the forward/reverse button (2)
is pushed to the left and drive mode is
selected (figure e).
• pull the trigger switch (1) to drive a screw
into the workpiece. Drill automatically stops
most screws flush in the material on the
first try. If drill stops sooner than desired,
release the trigger and pull trigger again.
• If a deeper screw is desired, continue to
hold the trigger switch. After a moment
the drill will begin to make short rotations
to drive the screw deeper at a more
controllable pace.
• Once the desired depth is reached,
release the trigger switch.
noTe: Similar to traditional drill/drivers – it is
important to apply firm pressure to the back
of the drill to ensure the screw bit doesn't slip
out of the screw head. If the screw bit does
slip out reinsert the screw bit and increase
your pressure to the back of the tool.
noTe: AUTOSENSE Technology works
with most material, but may not operate with
certain materials or screws.
e
STaTe of cHarGe IndIcaTor
(fIGure e)
The drill is equipped with a state of charge
indicator. This can be used to display the current
level of charge in the battery during use. It does
not indicate tool functionality and is subject
to variation based on product components,
temperature, and end-user application.
checking state of charge during use:
• Insert the battery (5) into the tool as
shown in figure B.
• press both mode select buttons (3) or
depress the trigger switch (1).
7
symbol.
symbol.
3
7