Télécharger Imprimer la page

Philips Flexcare+ HX6922 Mode D'emploi page 12

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
12
Quadpacer
-
The Quadpacer is an interval timer that has a short beep and pause
to remind you to brush the 4 sections of your mouth. Depending on
the brushing mode you have selected, the Quadpacer beeps at
different intervals during the brushing cycle. See section 'Brushing
modes' in chapter 'Using the Philips Sonicare' (Fig. 7).
The Quadpacer feature on this type has been activated. To deactivate or
reactivate the Quadpacer feature:
1
Place the handle with a brush head attached on the plugged-in
charger.
2
Press and hold the mode button for 2 seconds.
You hear 1 beep to indicate the Quadpacer has been deactivated
,
or you hear 2 beeps to indicate the Quadpacer has been activated.
Cord wrap on deluxe charger (specific types only)
If your type includes the deluxe charger cover and base, the travel charger
is pre-installed inside the cover. If you want to shorten the mains cord,
you can store excess cord in the cord wrap feature built into the
charger base.
1
To separate the charger cover from the charger base, press the
two grey snap bars on the charger base and pull the white charger
cover upwards. (Fig. 9)
2
Wrap excess power cord around the grey charger base as shown
in the picture. Be sure to wrap the cord on the inside of the two
snap levers. (Fig. 10)
3
When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base. (Fig. 11)
4
To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger
and use it without the charger cover and charger base.
35_021_4216_1_DFU-SImple_A6_v5.indd 12
24/11/17 13:32

Publicité

loading