Panasonic KX-PRLA20C Manuel D'installation page 3

Battery installation/Battery charging
When the language selection is displayed after installing the batteries for the first
time, you can select your desired language.
MbN: Select the desired setting. a MSAVEN a MOFFN
Important:
R Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted in the base unit's operating
instructions.
R USE ONLY rechargeable Ni-MH batteries AAA (R03) size (
R Do NOT use Alkaline/Manganese/Ni-Cd batteries.
R Confirm correct polarities (
Charge for about 7 hours.
R Confirm "Charging" is displayed (
R When the batteries are fully charged, "Fully charged" is displayed.
Note:
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
charge again.
Registering a handset to a base unit
1
Base unit:
Press and hold M
R If all registered handsets start ringing, press M
2
Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
PRLA20C_(en-en)_0110_ver.030.pdf
,
N for about 5 seconds.
this step.
is displayed.
3
, ).
2
).
1
) and the charge contacts with a dry cloth and
N again to stop, then repeat
Installation
1
).
2
3
2014/01/10 21:27:19