Ninka Qanto Id A5 Mode D'emploi page 31

LED lamp
Electronic scrap
• Remove the LED lamp plug from the connection bushing and
pull the cable out of the cable duct.
• Loosen both fastening screws of the LED lamp using a screw-
driver TX20.
• Remove the LED lamp.
Control unit
Electronic scrap
• Remove all connecting cables from the control unit.
• Loosen the fastening screws.
• Remove the control unit.
Switch cabinet
Electronic scrap
• Remove all connecting cables from the switch cabinet.
• Loosen the fastening screws.
• Remove the switch cabinet.
Qanto_Id_A5_ 0000.50.65062-US
EN
31