Initialisation - Ninka Qanto Id A5 Mode D'emploi

EN

6.8 Initialisation

Before and during initialisation, check and make sure that the
safety switches are contacted.
The lifting system is initialised by pressing and holding the
button. It must be kept pressed until the drive reaches the lower
end position. As soon as the drive stops in the lower end position,
the button must be released for 2-3 seconds.
Then the button must be kept pressed for an additional
6-8 seconds. After that, the initialisation procedure is complet-
ed. During initialisation, the trays are lowered by 5 mm and then
raised again.
Please do NOT release the button during initialisation.
If the button is released before the procedure has been concluded,
the initialisation procedure is interrupted and must be restarted. If
an initialisation procedure is interrupted, an upward movement of
the trays is not possible.
During initialisation, the safety switches must be contacted. If the
initialisation procedure cannot be concluded, the upper tray must
be removed and the two safety switches must be pressed manual-
ly during the initialisation procedure.
23
Qanto_Id_A5_ 0000.50.65062-US