Assembly Of Qanto - Ninka Qanto Id A5 Mode D'emploi

EN

5. Assembly of Qanto

!
WARNING
Anyone who performs connection or assembly work on Qanto or
uses Qanto must have access to these instructions for use. Follow
these instructions. Non-observance of the above mentioned instruc-
tions can lead to accidents resulting in resulting in serious injury or
electric shock.
If the product is visibly damaged, it must not be installed, as an error
may lead to injury or electric shock.
During the installation of Qanto, make sure there is sufficient clea-
rance for the movement of the lifting system, otherwise during
raising or lowering of the trays, serious injury may occur. When
Qanto is extended upward and to both sides, a clearance of about
7,88" (200 mm) to other cabinets or shelving must be observed.
Make sure the cables are undamaged, otherwise there is a risk of
electric shock.
NOTICE
A clearance of 11,82" (300 mm) must be observed between Qanto
and a gas stove, as heat may damage the unit and its components.
The electrical system of Qanto must be accessible (e.g., a double
socket under the cabinet near the base).
If the control unit causes unusual noises or odours during operation,
interrupt the power supply, to avoid serious damage.
10
Qanto_Id_A5_ 0000.50.65062-US