Installation Instructions - Whirlpool Duet Sport Kenmore HE2 Instructions D'installation

WARNING
Excessive Weight Hazard
Use two or more people to move washer or dryer.
Failure to do so can result in back or other injury.
1. Move washer close to its final location. Leave room to work
behind washer. Do not remove the shipping bolts.
2. Level washer as described in washer Installation Instructions.
3. Place a protective covering, such as cardboard or a blanket,
on the floor. Gently lay the dryer down with its back on the
covering.
4. If the dryer has the feet already installed, remove them. Do not
install the dryer feet.
5. Remove the adhesive protective strip from one of the long
foam pads. Starting from the front of the dryer, press the
adhesive side of pad on one of the sides of the dryer,
covering the small ribs. Stay within the edges of the bottom
frame of the dryer.
Install a foam pad on other side, being sure to cover the small
ribs. Install the remaining foam pads on the front and rear of
the dryer, covering the small ribs.
NOTE: Be sure foam pad does not stick out past the front toe
panel edge of the dryer.
A
B
B
A. Foam pad
B. Small ribs
C. Foam pad flush with edge of front toe panel
6. Lift the dryer back to upright position and move to front of the
washer.
7. Lift the dryer up and set on top of washer so that the back of
the washer and dryer are lined up.

INSTALLATION INSTRUCTIONS

C
8. Remove the 2 plastic clips, 2 brackets and 4 pan head sheet
metal screws from the parts bag.
9. Take a plastic clip and with the flat side facing out, push it
down onto the lower edge of the slot in the dryer back.
A
A. Plastic clip
B. Slot
Repeat on other side.
10. Place the hooked end of the bracket over the plastic clip.
Rotate down against back of washer. Adjust the dryer
forward or backward as needed and attach bracket to washer
with 2 pan head screws. Tighten screws securely.
A
B
A. Hooked end
B. Bracket
C. Slot
Repeat on other side.
11. Follow the Installation Instructions that came with your
washer and dryer to remove the shipping bolts and complete
the installation.
B
C
5