Tanita BC-732 Mode D'emploi page 8

TAKING WEIGHT MEASUREMENT ONLY
Press the Weight-only button. Step onto the scale after "0.0" is shown on the display. The body weight value will appear.
The display will light for about 20 seconds, and then the power will automatically turn off.
TROUBLESHOOTING
If the following problems occur ...then...
• A wrong weight format appears followed by kg, lb, or st-lb.
Refer to "Changing the weight mode" on p. 3.
• "Lo" appears on the display, or all the data appears and immediately disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the
accuracy of your measurements. Change all the batteries at the same time with new AAA-size batteries.
Note: Your settings will not be erased from the memory when you remove the batteries.
• "Err" appears while measuring.
Please stand on the platform keeping movement to a minimum. The unit cannot accurately measure your weight if it detects
movement.
When the Body Fat % is more than 75%, readings cannot be obtained from the unit.
When the BMI is less than 6, readings cannot be obtained from the unit.
• The Body Fat Percentage measurement does not appear.
Your personal data has not been programmed. Follow the steps on p. 4.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the
measuring platform.
• "OL" appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
Specifications
BC-731 / 732
Weight Capacity
150 kg (330 lb) (23 st 8 lb)
Weight Increments
0.1 kg (0.2 lb) (0.2 lb)
Body Fat Increments
0.1%
Personal Data
5 memories
Power Supply
4 AAA batteries (included)
Power Consumption
30 mA
Measuring Current
50 kHz, 6.25 kHz, 100 µA
6
Notice:
These marks can be found out on contaminant-containing
Batteries: Pb Pb = Battery contains lead,
Cd Cd = Battery contains cadmium,
Hg Hg = Battery contains mercury.
Not allowed to mix batteries with consumer
wastes!
As consumer you are legally bound to return used or discharged batteries.
You can deposit your old batteries at the public collecting points in your
town, or wherever the corresponding batteries are sold and specifically
marked collecting boxes have been set up. In case of scrapping the
apparatus, the batteries should be removed from it and deposited at the
collecting points as well.
This device meets the EMC Directive 2004/108/EC and the
RoHS Directive 2011/65/EU.