Troubleshooting - Wolf ICBOG30 Guide D'installation

Masquer les pouces Voir aussi pour ICBOG30:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
I NSTAL L AT IO N
Side Burner Installation
ELECT R I CAL C O N N ECT IO N
Depending on the serial number of the grill, there may
1
be one or two connectors near the front of the grill just
above the manifold. Locate the connectors by looking
above the manifold near the front of the grill.
Remove the unpopulated connector housings from the
2
wire harnesses coming from the grill as shown in the
illustration below.
Attach the appropriate connector housing from the side
3
burner to the grill. Refer to the illustration below.
UNPOPULATED
CONNECTORS
Connectors.
Connector housing.
10 | English
LP GAS CO NNECTI ON
Connect 2-stage LP gas regulator to flare tee at location
1
shown. Connect flare swivel connector to one end of
flare tee. Refer to the illustration below.
Connect regulator assembly to flexible gas line coming
2
into grill cart from side burner as shown in the illustration
below.
Connect regulator assembly to grill manifold at flare
3
swivel connector as shown in the illustration below.
Reinstall rear panel and door of grill cart. Reposition grill
4
drip tray. Place burner cap on burner head, place grate
on burner pan and affix knob to bezel with bezel nylon
liner.
GRILL
LP GAS
MANIFOLD
REGULATOR
FLARE
SWIVEL
FLARE
TEE
FLEXIBLE
GAS LINE
LP gas regulator assembly.
LP gas connection.
NAT UR AL GA S C O N NE C TIO N
Split high pressure natural gas line into two lines, one to
1
attach to grill natural gas regulator and one to attach to
side burner via flexible line and
1
/
" NPT adapter. Place
2
flexible gas line through cart access hole.
Place flexible gas line through cart access hole and
2
attach to side burner regulator at pipe elbow. Elbow may
be rotated to face downward for larger adapters. Do not
rotate elbow upward. Refer to the illustration below.
AUXILLARY
Natural gas connection.
HARNESS
TR OU B L E SH OOTIN G

Troubleshooting

IMPORTANT NOTE:
If the outdoor gas grill does not operate
properly, follow these troubleshooting steps:
Verify electrical power is supplied to the grill.
Verify proper gas supply.
Verify the gas supply shut-off valve is in the open
position.
If the outdoor gas grill does not operate properly, contact
Wolf factory certified service. Do not attempt to repair
the grill. Wolf is not responsible for service required to
correct a faulty installation.

Publicité

Table des Matières
loading

Table des Matières