GE GWE19JGLBB Manuel Du Propriétaire Et Instructions D'installation page 26

INSTALLING THE REFRIGERATOR
2A SLIDE-ON TYPE FREEZER
HANDLE
aligning the slots inside the handle endcap with the
mounting fasteners. Being careful to avoid scratching
the door finish, slide the handle to the right until it comes
to a hard stop.
Slot
Endcap
towel wrapped around head of hammer can be used as
well), to gently tap the left side of handle until the handle
no longer moves left or right. A few taps should be
used rather than using heavy force witch can cause
handle/endcaps to get damaged.
26
Installation Instructions
2B FREEZER HANDLE WITH
SET-SCREWS
IMPORTANT:
tighten set screws.
Tools Provided:
however, the installation process is the same.
Remove any protective film from the door
A
or drawer fronts before installing handles (if
applicable).
Remove handle from packaging and locate
B
C
Place the handle over the mounting fasteners
until it is flush against the surface of the door.
Tighten both set screws in the handle end
until the handle will not hang loose or fall
E IMPORTANT: Hold the handle firmly against
the door, make sure there are no gaps
between the handle end caps and the door,
and fully tighten the set screws.
To remove, reverse the installation process.
49-1000472 Rev. 6