Section 1 Set-Up & First Brew; Set-Up & First Brew; Setting Up Your Brewer - Keurig Platinum B44 Manuel D'utilisation

SECTION 1
You cannot use your Keurig Brewer until
IMPORTanT:
it has been set-up for its first use as set forth below.
If Brewer has been exposed to temperatures
nOTE:
below freezing, allow Brewer at least two hours to
reach room temperature before brewing. A frozen
or extremely cold brewer will not operate.

Setting Up Your Brewer

1
fig.
Unwrap cord and plug the Brewer into a
1.
grounded outlet. Remove all pieces of
packing tape.
2. Place a Large Mug (8 oz. minimum) on
the Drip Tray Plate.
3. Remove the Water Reservoir from Brewer by
first removing Lid from Reservoir (fig. 1), then
lifting Reservoir straight up and away from
Brewer (may be tight). Rinse with fresh water.
Fill Water Reservoir with bottled or filtered
4.
water so that the water level reaches the line
just below the top edge of the clear viewing
area. (Be careful not to over fill.)
Set-Up & First Brew
Place Water Reservoir base into the left side
5.
2
fig.
Lock Tabs
of the Brewer and be sure the Water Reser-
voir Lock Tabs engage with the Brewer (fig. 2).
Replace Lid on Water Reservoir.
Press Power Button found on upper right panel
6.
of the Brewer. The green light next to the Power
Button will become illuminated.
NOTE: A K-Cup should not be used for
this Sequence
NOTE: If the Water Reservoir is empty or
not in place on the Brewer, the blue light next
to 'ADD WATER' on the LED Control Center will
3
be illuminated. The Small Mug Button will
fig.
not be activated until water is added to the
Water Reservoir.
ADD WATER The Brewer will automatically fill with water
7.
DE-SCALE and then the water will be heated. This will take
HEATING
about 4 minutes. During the heating period the
AUTO OFF
red light next to 'HEATING' on the LED Control
POWER
Center will become illuminated. Once the water
is heated, the red light will turn off and the
Small Mug Button will flash.
NOTE: Do not lift Brewer Handle during this
'heating period'.
Small cup
6
.