Section 4 Set-Up & Operation Initial Cleansing & First Brew - Keurig K-Cup K10 MINI Plus Manuel D'utilisation

SeCtIon 4
Set-Up & Operation
Initial Cleansing & First Brew
CAUTION: Two sharp needles are used to puncture the
K-Cup packs. One is above the K-Cup Pack Holder and
® ®
the other is in the bottom of the K-Cup ® Pack Holder. To
avoid risk of injury, do not put your fingers inside the
K-Cup ® Pack Assembly Housing.
BREW BREW
CAUTION: During the brewing process, the water
gets extremely hot. To avoid risk of injury, do not
lift the Handle or open the K-Cup Pack Assembly
®
Housing until brewing is complete.
Remove all tape and cardboard.
1
Perform an initial cleansing Plug the Power Cord into an
independent, grounded outlet.
brew before making your
first beverage. Follow these
instructions but do not insert
a K-Cup pack.
®
8
For accurate measuring, do not fill if the
Handle is up. In the down position it prevents
water from entering the lower heating
compartment.
2 3
Press the Power Button. The Add Water Indicator Lift the Cold Water Reservoir Lid.
will flash blue.
The Power Button does not illuminate.
MAX
10 oz.
8 oz.
6 oz.
Min
4
Pour water anywhere within the Cold Water
Reservoir until it reaches up to the rim of your
desired fill level on the Water Level Guide
(minimum of 6 oz.). Lower the lid.
For accurate measuring, do not fill if the
Handle is up.
Bottled or filtered water is recommended;
distilled or reverse osmosis water is not.
9