Télécharger Imprimer la page

Fimap FV P65.2 WDB Manuel D'utilisation Et D'entretien page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DANGER:
To reduce the risk of fire, electric shocks or injury, please read and follow the safety instructions
and warning indications before using. This vacuum cleaner has been designed to be safe
when it is used for cleaning in the specified manner. If damage to electrical or mechanical
components is found, the vacuum cleaner and/or the accessory must be repaired at the
relative authorised service centre or else at the manufacturer before use, in order to prevent
further damage to the appliance or physical injury to the user.
Before connecting the appliance to the electricity socket, make sure the electrical information
on the plate corresponds to that of the mains supply. The appliance must only be powered
with alternating current and voltage equal to that shown on the serial number plate.
The power supply cable outlet must have an earth connection in compliance with the regulatory
standards.
Before using, check for any damage on the connection cable and on the power plug. If the
cable is damaged, immediately contact a specialist technician for restoring normal operations.
Connect the appliance only to an electrical connection installed by an electrical installer in
conformity with IEC 60364-1.
Never touch the power plug with wet hands.
Make sure that the cable to the mains or the extension cable have not been damaged by
having been walked on, crushed, pulled or the like. Protect the cable from heat and from
contact with oils or sharp edges.
Regularly check that the cable connecting to the mains is not damaged, for example with
signs of ageing or cracks. If there is damage, the cable must be replaced by a specialist
technician or else by a technician with similar qualifications before using the appliance again.
Protection against splashes of water and the mechanical strength need to be ensured also
after any replacement of the joints of the power cable or the extension cable.
Do not clean the appliance with a hose or a jet of high pressure water (risk of short-circuit or
other electrical faults).
ATTENTION:
The procedure causes short-term reduction in voltage.
In unfavourable grid conditions the other appliances could be damaged.
This damage could occur if the grid impedance is less than 0.15Ω.
DANGER:
Never use with a damaged cable or plug. When removing from an electrical socket, pull
the plug and not the cable. Do not handle the plug or the vacuum cleaner with wet hands.
Deactivate all the controls before connecting or disconnecting from the electrical socket.
Do not pull or transport the appliance by the cable, do not use the cable as a handle, do not
close a door on the cable, and do not pull the cable around edges or sharp corners. Do not
pass the vacuum cleaner over the cable. Keep the cable away from hot surfaces.
CONNECTION TO THE ELECTRICITY GRID
USE - EMPLOYMENT
14

Publicité

loading

Ce manuel est également adapté pour:

Fv p65.3 wdbFv a75.2 wdbFv a75.3 wdb