Mounting And Electrical Connection - Knick VariTrans P2900 P2 Série Manuel Utilisateur

Mounting and Electrical Connection

WARNING! Shock potential.
For applications with high working voltages, take measures to prevent
accidental contact and make sure that there is sufficient distance or
insulation between adjacent devices.
The devices must be installed under conditions that ensure pollution
degree 2 or better.
The devices are snapped onto DIN rails in accordance with EN 60715
with a width of 35 mm. They are secured on the side using suitable
end brackets. See dimension drawing for terminal assignments.
Wire cross-section: 0.2 mm 2 ... 2.5 mm 2 (AWG 24-12).
Note: Only use copper cables that are process temperature resistant
to at least 75 °C.
52